Pultec latency, Pultec eqp-1a screenshot, Pultec eqp-1a controls – Universal Audio UAD POWERED PLUG-INS ver.6.1 User Manual
Page 476: Pultec eqp-1a screenshot pultec eqp-1a controls
UAD Powered Plug-Ins Manual
- 476 -
Chapter 47: Pultec and Pultec-Pro
Pultec Latency
The Pultec and Pultec-Pro plug-ins introduce an additional 13 samples of de-
lay due to upsampling when the session sample rate is below 100 kHz. This
additional latency does not occur at sample rates above 100 kHz. You may
enter a value of 13 in the “Samples” parameter in DelayComp or TrackAdv
to compensate. See
“Compensating Upsampled Plug-Ins” on page 108
for
more information.
Note:
Compensating for Pultec and Pultec-Pro is not required if the host appli-
cation supports full plug-in delay compensation throughout the signal path, or
when it is used on outputs. See
“Host PDC Implementation” on page 101
.
Pultec EQP-1A Screenshot
Pultec EQP-1A Controls
The EQP-1A can control three frequency ranges simultaneously, using three
groups of interacting parameters.
The first group controls the low frequencies and has three controls: boost, at-
tenuation, and frequency select. The second group controls the high frequen-
cies and has three controls: boost, bandwidth, and frequency select. The third
group also controls the highs and has two controls: attenuation amount and
frequency select.
The placement and grouping of the sections and their related controls are
shown in
Figure 150. The Pultec EQP-1A Program Equalizer plug-in window