Universal Audio UAD POWERED PLUG-INS ver.6.1 - Manual (Page 247)

UAD Powered Plug-Ins Manual - 247 - Chapter 20: EMT 250 Electronic Reverberator
Delay Delay program mode offers two independent delay processors, one each for
the left and right output channels. Up to 375ms delay time is available for
each channel. Delay repeats (feedback) are not available in Delay mode; use
Echo mode if delay feedback is desired.
Note: The maximum per-channel delay time of 375ms in Delay mode is ob-
tained by setting the coarse, fine, and predelay times to their respective max-
imum values.
Coarse Delay Time (Lever 1)
Lever 1 controls the coarse delay time for the currently selected channel (left
or right). The currently selected channel is defined by lever 3.
The coarse delay time range is 0 to 300ms, selectable via 16 steps. The
green LEDs on the right side of lever 1 display the current value; the red LEDs
on the left side of lever 1 are inactive.
Fine Delay Time (Lever 2)
Lever 2 controls the fine delay time for the currently selected channel (left or
right). The currently selected channel is defined by lever 3.
Fine delay times of 0ms, 5ms, 10ms, and 15ms are available. The green LEDs
on the right side of lever 2 display the current value; the red LEDs on the left
side of lever 2 are inactive.
Note: Levers 1 and 2 both control the delay time, but these parameters are
not individually exposed for external control surfaces and automation. In-
stead, a single delay time parameter is exposed for each channel, and levers
1 and 2 in the plug-in interface are both updated to match the value.
Channel Select (Lever 3)
In Delay mode, lever 3 selects which channel (left or right) the delay time pa-
rameters (levers 1 and 2) will affect. When lever 3 is in position “L” the left
channel delay time can be adjusted; when in position “R” the right channel
delay time can be adjusted.
The green LEDs on the right side of lever 3 display the channel selected for de-
lay time adjustment; the red LEDs on the left side of lever 3 are inactive.
Note: Lever 3 position “I” is a duplicate of position “II – L” in Delay mode.
Likewise, position “IV” is a duplicate of position “III – R.” All positions can be
used to select a channel for delay time adjustment.