Universal Audio UAD POWERED PLUG-INS ver.6.1 - Manual (Page 195)

UAD Powered Plug-Ins Manual - 195 - Chapter 15: CS-1 Channel Strip
Mode Pop-up
Menu
Determines the DM-1 effect mode. The available modes are: Chorus,
Chorus180, QuadChorus, Flanger1, Flanger2, Dual Delay, and Ping Pong
Delay. In addition to reconfiguring the DM-1’s settings, the Mode also deter-
mines the available parameter ranges for L/R Delay and Depth.
In Chorus mode, both oscillators (or modulating signals) are in phase.
In Chorus 180 mode, both oscillators (the modulating signals) are180 de-
grees out of phase (inverted).
In QuadChorus mode, both oscillators (the modulating signals) are 90 de-
grees out of phase.
In Ping Pong delay mode, you will only get a ping-pong effect if you have a
mono source feeding the DM-1 on a stereo group track or send effect. On a
mono disk track, it works exactly like Dual Delay.
Rate Knob Sets the modulation rate for the delayed signal, expressed in Hertz.
Depth Knob Sets the modulation depth for the delayed signal, expressed as a percentage.
In Dual Delay and Ping Pong Delay modes, adjusting the Depth and Rate con-
trols can offer some very otherworldly sounds.
LFO Type Pop-up
Menu
Determines the LFO (low frequency oscillator) waveshape and phase used to
modulate the delayed signal. The waveshape can be set to triangle or sine,
each with a phase value of 0, 90, or 180-degrees.
Recirculation
(RECIR) Knob
Sets the amount of processed signal fed back into its input. Higher values in-
crease the number of delays and intensity of the processed signal.
Recirculation allows both positive and negative values. The polarity refers to
the phase of the delays as compared to the original signal. If Recirculation dis-
plays a positive value, all the delays will be in phase with the source. If it dis-
plays a negative value, then the phase of the delays flips back and forth be-
tween in phase and out of phase.
In the flanger mode, Recir has the potential to make some very interesting
sounds. Try turning RECIR fully clockwise or counter-clockwise, and set the de-
lay to very short but different values.