GE Industrial Solutions Entellisys 5.0 Integrator's Guide - Manual (Page 57)

57
4
4 Modbus Memory Map
NOTE: A multiplier factor may be necessary in cases where an integer value is returned but the
Range and/or Step imply a greater precision. In these cases, it is necessary to divide the
returned value by 10 for a step of “0.1” or “0.5”; by 100 for a step of “.01”; and so on. Similarly, it is
necessary to multiply by these factors prior to writing a settings value. This note does not apply
to any step value greater than 1 (a step of “10” does not require a multiplier, for example). This
note also does not apply to values returned in floating point format. See the format codes at the
end of the map for more information.
NOTE: Discrete I/O output state registers (Contact Output x State - register range from x9180
to x91FF and Contact Output States - register range from xB256 to 0xB25D) contain correct
information only when FlexLogic Active register (x0034) contains value 1 (yes).
Addr Register Name Range Units Step For-
mat Factory Default
Product Information (Read Only)
0000 FBW Product Type 0 to 65535 --- 1 F716 0
0001 CPU Serial Number --- --- --- F203 "0"
0009 External Ethernet MAC Address --- --- --- F072 0
000C Reserved (3 items) --- --- --- F072 0
000F CPU Hardware Version 0 to 655.35 --- 0.01 F001 1
0010 CPU Firmware Version 0 to 655.35 --- 0.01 F001 1
0011 CPU Firmware Boot Code Version 0 to 655.35 --- 0.01 F001 1
0012 Build Date --- --- --- F200 "0"
0026 Synchronizer Board Status 0 to 1 --- 1 F102 0
0027 Synchronizer Board Frequency Setting 50 to 60 Hz 10 F001 60
0028 Last Energy Clear Date 0 to 4294967295 --- 1 F050 0
002A Last CPU Commissioned Date 0 to 4294967295 --- 1 F050 0
002C Expected Node Protocol Version 0 to 255 --- 1 F001 1
002D Summary Number --- --- --- F205 "0"
0033 Line Up 0 to 99 --- 1 F001 1
0034 System Frequency Detected 0 to 1000 Hz 1 F001 0