Biamp A4 - Manual (Page 109)

Component Objects
EXPO-D
EXPO-D blocks are similar to CobraNet Output blocks, except they
are designed for use with AudiaEXPO-D hardware specifically and,
therefore, automatically allow for Internal Propagation Delay.
CobraNet® Output blocks may be used with AudiaEXPO hardware,
but Internal Propagation Delay must be manually set (0.00mS).
Mute Out turns the output signal on/off. Level Out adjusts the relative
output volume. Invert Out reverses the polarity of the output signal.
CobraNet Bundle assigns digital audio data to a particular bundle. CobraNet Bundle
Numbers are used to match those of the actual AudiaEXPO hardware being used in the
system. Normally, 'unicast' bundles 256 ~ 65,279 are selectable. These are device
specific bundles (for exchange of digital audio with only one other device). Multicast
allows selection of bundles 1 ~ 255, which are not device specific (for exchange of
digital audio with multiple devices). Enable turns on/off the exchange of CobraNet
digital audio data from this device.
Right-clicking over certain settings will provide a menu of additional
options.
Telephone Interface
Telephone Interfaces provide connection and control via standard analog telephone lines, and
are available in pairs only as part of AudiaFLEX
hardware . A Telephone Interface may consist of
as many as five separate blocks, as determined during placement into the Layout via the Object
Toolbar . Two primary blocks represent the audio Receive and Transmit functions. Three other
control blocks may be added individually at any time, representing functions for Dialer, DTMF
Decode, and Control/Status.
89