Biamp A4 - Manual (Page 178)

Audia-Manual-A4
'Ignore' is selected, then the warning "Ignored '...' (object code '...') at
[__, __]" will be listed in the compile results. If the 'Prompt To Stop
Compilation On Warnings' flag is not set, then compilation proceeds
and 'Ignores' automatically.
Messages: The algorithm for the '__' block (object code '__') at [__,__] has been deprecated.
You should replace the existing block with a newly created one which uses the
most up to date algorithm.
You should replace the existing blocks with newly created ones which use the
most up to date algorithms.
Explanation: The first warning is issued for each DSP block in the layout that is considered
outdated. One of the subsequent messages will also appear, depending upon
whether there is only one outdated block or multiple outdated blocks detected.
Messages: The algorithm for the '__' block (object code '__') at [__,__] has been eliminated.
You should replace the existing block with a newly created one which uses the
most up to date algorithm.
You should replace the existing blocks with newly created ones which use the
most up to date algorithms.
Explanation: These messages are similar to the ones above. The difference is that they are
not warnings, but errors.
Message: Channel numbers have been reset in some audio I/O blocks.
Re-compile to update the channel number assignments.
Explanation: Channel numbers were assigned in an input/output object, and that
object was assigned to a specific Audia unit by fixed alllocation .
Therefore, the channel numbers also became fixed. Then the
Audia I/O configuration was changed in the Equipment Table .
Since the new I/O configuration has less input or ouput channels,
some channel numbers have become invalid.
158