Biamp A4 - Manual (Page 230)

Audia-Manual-A4
Command Dev # Attribute Inst ID Index 1 Index 2 Value Line Feed
GET 1 RMSMTRLVL 48 1 None None <LF>
Result: GET 1 RMSMTRLVL 48 1 <LF> (use GET/GETL commands only)
Generator Blocks
No Attributes are specified at this time
Instance ID
Audia uses an Instance ID number to specify the exact DSP block to be controlled. Custom
names (Instance ID Tags) may be assigned to DSP blocks, and used in lieu of Instance ID
numbers within ATP command strings. Instance ID Tags may be up to 32 characters, but may not
start with a number. If the Instance ID Tag includes spaces, it must be double-quote delimited
("Instance ID Tag") when used in a command string. The Instance ID number (and Instance ID
Tag) can be found by right-clicking the DSP block and selecting "Properties". Both identifiers are
available on the DSP Attributes 1 tab.
Instance ID Tag
Instance ID Tags are used as an alphanumeric substitution for the Instance ID when sending ATP
control strings. If the Instance ID Tag field is left blank, it is necessary to use the Instance ID.
The Instance ID Tag can not start with a numerical digit, and the tag can not contain the
ampersand (&), less than (<), greater than (>), single quote ('), and double quote (") symbols.
210