Biamp A4 - Manual (Page 122)

Audia-Manual-A4
cannot exceed 120 Watts.
Device IO indicates which hardware output is associated with that software channel. Fault L & T
indicate Load and Temperature fault conditions. Mute Out turns the output signal on/off. Gain
Out
adjusts the relative sensitivity of the amplifier. Invert Out reverses the polarity of the output
signal. Clip Limiter Out enables a limiter to prevent overdriving the amplifier. Peak Out indicates
the presence of signal levels that could overdrive the amplifier (if Clip Limiter Out disabled). Load
Impedance
selects the intended speaker load (4, 6, or 8 ohms) for both channels. Selected or
not, Auto Detect always insures that the lowest load detected on either channel is designated for
both channels (if actual loads are unequal, the higher load will produce less power).
Control Output Nodes
on the bottom of the
Power Amp block will
indicate channel fault
conditions.
Networked Paging Station-1
Networked Paging Station-1 is a microphone console that integrates with AudiaFLEX networks
via CobraNet, using a single CAT5 cable to carry audio, control, and Power-over-Ethernet (PoE).
Networked Paging Station-1 units
are represented in the Layout as
blocks that have only a single audio
output, which will be connected to a
Paging Zone Router . When placed
from the Object Toolbar, each block
may have up to 32 programmable
102