Biamp A4 - Manual (Page 229)

System Control
Presets Attribute Commands Index Value Range
Preset PRESET RECALL None 1001 ~ maximum number
of presets
Note : Instead of SET, SETL, GET, GETL, INC, or DEC; the Preset attribute uses RECALL as the
command. Preset numbers begin at 1001. Regardless of preset name, the first preset defined is
1001, the second is 1002, and so forth. However, the numbers of any deleted Presets will not be
available. Since Presets apply to entire systems, the Device Number will always be 0 for Preset
strings.
Example: Recall Device 0 Preset number 1001.
Command Dev # Attribute Inst ID Index 1 Index 2 Value Line Feed
RECALL 0 PRESET None None None 1001 <LF>
Result: RECALL 0 PRESET 1001 <LF> (use RECALL instead of SET/GET commands)
Meter Blocks
Meters Attribute Commands Index Value Range
Signal Present Meter SPMTRSTATE GET 1 0 = no signal present
1 = signal present
Peak Meter PKMTRLVL GET, GETL 1 -100 ~ 36 *
RMS Meter RMSMTRLVL GET, GETL 1 -100 ~ 36 *
Logic Meter LGCMTRSTATE GET 1 0 = no signal present
1 = signal present
* Can contain a decimal number.
Note: Meters only use GET and GETL commands, which do not include a Value. Instead, Audia
will respond to these GET/GETL commands with the requested value (current level).
Example: Get Device 1 RMS Meter Level at Instance 48 Meter 1.
209