Biamp A4 - Manual (Page 17)

Table Of Contents
xvii
226. _____________________________________________________________
_________________________________________________________________________________ 171 Hardware
227. _____________________________________________________________
____________________________________________________________________ 171 Rear Panel Connections
228. _____________________________________________________________
______________________________________________________________________ 173 Front Panel Indicators
229. _____________________________________________________________
_____________________________________________________________________ 174 Input/Output Expanders
230. _____________________________________________________________
_______________________________________________________________________ 176 System Connections
231. _____________________________________________________________
____________________________________________________________________________ 179 System Control
232. _____________________________________________________________
_____________________________________________________________________ 179 Software User Interface
233. _____________________________________________________________
234. _____________________________________________________________
235. _____________________________________________________________
S
points
185
IN
DEC- Tells Audia that a DSP attribute is to be decremented by a specific amount 185
Remote Control Bus ________________________________________________________________________ 180
Remote Control Bus Hub ____________________________________________________________________ 182
Third-Party Control
RS-232 and Telnet Protocol
_________________________________________________________________________ 182
182
236. _____________________________________________________________
_________________________________________________________________________________ 182 Overview
237. _____________________________________________________________
____________________________________________________________________________ 184 RS-232 Control
238. _____________________________________________________________
_____________________________________________________________________________ 184 Telnet Control
239. _____________________________________________________________
________________________________________________________________________________ 185
ET – Tells Audia that a DSP attribute is to be set to a specific value – may contain negative numbers and/or decimal
Command
GET - Tells Audia that a DSP attribute is to be read – the response may contain a decimal point and/or a negative
number (see Responses).
185
185
C - Tells Audia that a DSP attribute is to be incremented by a specific amount