Manual changing of the process setpoint, S/hart) – Burkert Type 8635 User Manual
Page 108
Advertising
106 - 8635
O
PERATING THE
P
ROCESS
C
ONTROLLER
(S/HART)
If the supplementary
function P.CONTRL / P.CO SETP / SETP INT (setting of
the setpoint via keys) was specified on configuration, then with the display
SP set (setpoint) and on pressing one of the arrow keys for longer than 3
seconds, the mode for changing the process setpoint can be activated. After
release of the key, the first digit of the process setpoint flashes.
The first digit of the process setpoint can be set.
After confirmation with the MANUAL / AUTOMATIC key, the set value is
stored.
Manual changing of the process setpoint
or
> 3 s
or
In the same manner, the other digits are set. After confirmation of the fourth digit, the display returns to
the previous mode.
Advertising