Burkert Type 8635 - Manual (Page 98)

96 - 8635
O
PERATING THE
P
ROCESS
C
ONTROLLER
(S/HART)
P.CO SCAL
Scaling the process controller
(**) This setting is active only when P.CO SETP / SETP EXT has been selected.
(*) This setting specifies the reference range for the deadband of the process controller and for the
analog repeat of the process value (option).
Position of the decimal point for process value
and setpoint (setting range: 0 ... 3)
Lower scaling value for process value; the value
is assigned to 4 mA.
(*)
Upper scaling value for process value; the value
is assigned to 20 mA.
(*)
Lower scaling value for process setpoint; the
value is assigned to 4 mA.
(**)
Upper scaling value for process setpoint; the
value is assigned to 20 mA.
(**)