Burkert Type 8635 - Manual (Page 133)

8635 - 131
O
PERATING VIA THE
HART
HAND TERMINAL
(HART)
Specify a process setpoint between PVmin (scaled minimum process value) and PVmax (scaled
maximum process value).
While the setpoint is being specified via the HART interface, SIDE Control is switched to internal
setpoint setting.
Using F4 - ENTER, transmit the value entered to the SIDE Control.
Using F3- ABORT, quit the entry mask. A message appears as shown below.
Message after quitting Digital control
By confirming with F4 - OK you return to the Main menu.
If the setpoint was specified externally before starting Digital control, this mode is restored after
confirmation with F4 - OK.