Burkert Type 8635 - Manual (Page 87)

8635 - 85
O
PERATING AND
C
ONTROLLER
F
UNCTIONS
Operating the process
Each time after switching on the voltage supply, the SIDE Control is automatically in the process
operating level. To change to the process operating level from the configuration level, confirm the menu
item
END by pressing the MANUAL/AUTOMATIC key.
In the process operating level, the normal controlled operation is executed and monitored (in the
AUTOMATIC mode), and the valve opened or closed by hand (MANUAL mode).
Changing between the operating modes:
Operate the MANUAL/AUTOMATIC key to switch between the MANUAL and AUTOMATIC
modes.
Both in the MANUAL and the AUTOMATIC modes, you can change to the configuration
level by pressing the MANUAL/AUTOMATIC key for longer than 5 seconds.On switching
back to the process operating level, the operating mode is resumed that was set before
switching over.
5 sec
Operating mode Display
AUTOMATIC An apostrophe (') runs continuously
from left to right.
HAND -