Burkert Type 8045 User Manual
Operating instructions, Type 8045
Advertising
Table of contents
Document Outline
- Type 8045
- Table of Contents
- 1. About the manual
- 2. Intended use
- 3. Basic safety information
- 4. General information
- 5. Description
- 6. Technical data
- 7. Installation and commissioning
- 8. Operating and functions
- 8.1. Safety instructions
- 8.2. Operating levels of the device
- 8.3. Description of the navigation keys and the status LEDs
- 8.4. Using the navigation keys
- 8.5. Details of the Process level
- 8.6. Details of the Parameters menu
- 8.6.1. Choosing the display language
- 8.6.2. Choosing the flow rate units, the number of decimals and the units of the totalizers
- 8.6.3. Entering the K factor of the fitting used:
- 8.6.4. Determining the fitting K factor using a teach-in procedure
- 8.6.5. Configuring the outputs (general diagram)
- 8.6.6. Configuring the AO1 current output
- 8.6.7. Configuring the transistor output DO1 as a pulse output
- 8.6.8. Configuring the transistor output DO1 to switch a load depending on two threshold values
- 8.6.9. Configuring the transistor output DO1 to switch a load when the fluid direction changes
- 8.6.10. Configuring the transistor output DO1 to switch a load when a warning message is emitted by the device
- 8.6.11. Configuring the DO2 and DO3 relay outputs
- 8.6.12. Configuring the DI1 digital input
- 8.6.13. Configuring the filter of the measured flow rate
- 8.6.14. Resetting both totalizers
- 8.6.15. Configuring the electric network frequency
- 8.6.16. Parameterizing the cut-off flow rate
- 8.6.17. Setting the brightness of the display and how long it stays ON, or deactivating the backlight
- 8.7. Details of the Test menu
- 8.8. Details of the Information menu
- 9. Maintenance and troubleshooting
- 9.1. Safety instructions
- 9.2. Cleaning the device
- 9.3. Cleaning the flow sensor
- 9.4. Replacing the seal on a 8045 with G2" nut
- 9.5. If you encounter problems
- 9.5.1. Resolution of problems when the device status LED is OFF
- 9.5.2. Resolution of problems without message generation but device status LED ON
- 9.5.3. Resolution of problems without message generation and device status LED green
- 9.5.4. Resolution of problems without message generation and device status LED red
- 9.5.5. Resolution of problems without message generation and device status LED orange
- 10. Spare parts and accessories
- 11. Packaging, Transport
- 12. Storage
- 13. Disposal of the product