SecurityMan Cyber Eye - Manual (Page 11)

CyberEyes User’s Manual Rev.1 9
Step 7: Auto Recording (time-lapse recording)
To activate Motion Recording,
please go to the Storage tab by
clicking on it.
Then make sure there is a check
mark beside Only record motion
frames in scheduled-recording
mode. CyberEyes, by default,
would already have a check mark
beside this choice.
Click OK to finish configuring
motion detection parameters and
start Motion Recording.
In addition to Schedule Recording
and Motion Recording is Auto
Recording (or time-lapse
recording). Please go to Channel
Settings and choose the Storage
tab by clicking on it.
To activate Auto Recording, make
sure there is a check mark beside
the Enable auto-record choice.
Once a check mark is placed beside
this choice, you will be able to input
a numeric value (between 1 to 15)
in the Auto record xx images
every. The numeric value xx
determines the number of frames
per second CyberEyes is going to
record disregard of any detected
motion or recording schedule. If
you input the numeric value as 5,
then CyberEyes is going to record 5
frames per second continuously
disregard of any detection motion or
recording schedule.
Click OK to finish configuring Auto
Recording (or time-lapse
recording).