SecurityMan Cyber Eye - Manual (Page 39)

CyberEyes User’s Manual Rev.1 37
To remove device:
Ÿ
On the Devices tab, click on the channel that you wish to remove, and click Remove Device under the
device list table. A prompt will appear.
After you are done, click OK to save the changes and close the dialog box.
Channel Settings
You can configure different settings, such as the recording method, alarm notification type, motion detection
areas, motion sensitivity, etc. for each video channel depending on your requirements. Click on a channel that
you wish to configure its settings, and click Channel Settings to bring up the Channel Settings dialog box.
Click Yes to remove the video channel. Click No to close the
dialog box and the video input source will not be removed.
Device Properties
This function allows you to modify
appropriate video format (NTSC or PAL) from
the Select TV Format pull-down menu. You
can change such camera parameters as
brightness, contrast, hue, saturation, and
sharpness based on your own preference.
There are two ways to go into the Device
Properties menu:
•
Right click on any icon except the one
that is grey-white (no video source has
been connected to this channel) in the
channel status area, and then click
Device Property from the pop-up
menu, or
Ÿ Click System Setting in the control bar.
In the System Settings window, click on
any channel except the one that has not
been added yet under device list, and
then click Device Properties.