SecurityMan Cyber Eye - Manual (Page 73)

CyberEyes User’s Manual Rev.1 71
threshold. Here you must pay attention to keep an average level suitable for your environment, for an
extra high sensitivity (the red horizontal line is too low) will result in fairly frequent false alarms even
though there is not any detected motion.
Ÿ If the alarm sensitivity is too high (the red horizontal line is too low), increase the noise or motion threshold.
Here you must pay attention to keep an average level suitable for your environment, for an extra low
sensitivity (the red horizontal line is too high) will result no alarms even though there is detected motion.
Web Service
CyberEyes not only operates in LAN, but also over the Internet. Even if you are far away from your host PC
(the PC with the DQP connected and CyberEyes installed), you can still remotely view live images or play back
previously recorded images from a remote computer with just a standard web browser without interrupting the
recording at the host PC. This function makes the task of administration extremely flexible. All you need is to
gain an access to the Internet and type in the IP Address of the host computer from a standard Internet browser,
and you will be able to monitor remotely anywhere, anytime.
To use web service:
Input the IP address of the host PC (the PC with the DQP connected and CyberEyes installed) and press the
Enter key. You will be directed to a homepage similar to the one below.
Choose the
appropriate user
type, such as
Administrator,
User, or Guest,
and key in the
correct
password, and
click Enter to
enter the web
service
Homepage.