Agilent Technologies Agilent E6474A - Manual (Page 103)

Get Assistance, if You Need It 6
Agilent E6474A User’s Guide 103
• If you have a Sagem phone that is capable of operating in
Data mode, refer to “Changing a Sagem phone’s operating
mode" on page 103.
• In the System Setup view, right-click another COM port, then
select the Refresh Port command.
• Use a systematic approach to isolate a hardware problem. If
available, replace a suspected defective device or cable with a
known working device or cable. Replace only one component
at a time, then retest.
Setting an iDEN phone’s baud rate
The baud rate for any iDEN phone must be set to 19200 baud,
otherwise the phone may not be identified. The following is the
procedure for the i1000 Plus phone.
1 Power up the phone. Wait for “Phone Ready” to be displayed.
2 Press the Menu key 3 times.
3 Press the key under Prgm shown in the display. The
Programming Menu is displayed.
4 Press the key under OK in the display.
5 Press the right arrow key until Set Baud Rate: <value> is
displayed.
6 Press the key under OK in the display.
7 Press the right arrow key until 19200 is displayed.
8 Press the key under OK in the display.
9 Press the key under Exit in the display.
Changing a Sagem phone’s operating mode
The Sagem OT-55P phone can operate in either of two modes,
Trace or Data. A communication error may occur if the wrong
mode is selected. If you are making parameter measurements, it
must be set to Trace mode.
Refer to the phone manufacturers instructions for details on
how to change the phone mode settings.