Agilent Technologies Agilent E6474A - Manual (Page 84)

84 Agilent E6474A User’s Guide
4 Use Your System
Configuring devices and views
Once a device has been identified by the system it needs to be
configured for measurement and data recording.
Each device has its own properties dialog box. This dialog box
allows you to set various measurement and test parameters for
that particular device.
Further test configuration can be done in the measurement
views associated with the relevant device.
To configure a device
1 Select the device.
2 Right-click on the device.
3 Select Properties from the pop-up menu. The properties
dialog box for that device will appear.
4 Step through the tabbed areas of the properties dialog box
and configure the device as required. For more information
on device properties, select F1 or click the Help button. Refer
to
Figure 43 on page 85 for an example of a typical properties
dialog box.
5 Once the device properties have been configured, close the
dialog box (Select OK).
6 Select File > Save to save your plan file.