Agilent Technologies Agilent E6474A - Manual (Page 83)

Use Your System 4
Agilent E6474A User’s Guide 83
Figure 42 System Setup View with a phone identified on COM 1
Enabling the devices
Note that the check box next to each device is checked,
indicating that the device is enabled for data collection. Phones
and receivers are automatically enabled after you identify these
devices. The navigator, however is not automatically enabled.
Before you begin logging data or Live Mode, verify the following:
• Verify that each phone or receiver is enabled. Click the check
box to enable the NMEA Navigator. The navigator supplies
data to plot your position on the Route Map.
• Click the check box to enable the In-Building Navigator if you
have E6474A, option 030, indoor mapping. This allows you to
use the In-Building Route Map for manually plotting your test
route.
• Click the check box to enable the Simulated Navigator when
you need to isolate a problem, and do not require real
navigation data.