Agilent Technologies Agilent E6474A - Manual (Page 172)

172 Agilent E6474A User’s Guide
D Permanent In-Vehicle Hardware Installation
Installation Guidelines
Use the following guidelines for installing the system hardware.
• The dimensions of the in-vehicle rack with the navigator
installed are approximately:
• Width: 11 inches / 280 mm
• Depth: 10.5 inches / 265 mm (allow an additional 3 inches
/ 76 mm for handles)
• Height (with E746xx): 6.5 inches / 164 mm
• Because every installation has different requirements, the
installer must select the appropriate mounting hardware.
• If you are using a permanently installed antenna, follow the
antenna manufacturer’s installation instructions. Antennas
should be spaced at least 18” apart to avoid interference.
WARNING
Choose suitable locations for the navigator and E6473B, the phones,
the speakers, and the computer, that will not interfere with the
operation of the vehicle, but will allow access to the cable
connectors. If the system includes an E645xx receiver, allow room
for its mounting plate.
Observe local regulations and restrictions when installing the
equipment and making electrical connections to the vehicle.
Use caution when drilling holes and working around critical areas,
such as the fuel tank, fuel lines, battery, engine compartment,
electrical harnesses, fuse block, and the exhaust system.
Disconnect the battery before making permanent connections to the
electrical system.