Agilent Technologies Agilent E6474A - Manual (Page 58)

58 Agilent E6474A User’s Guide
3 Set Up Your System
Indoor Setup
Overview
This section contains instructions for setting up a portable or
indoor system. A single lithium-ion battery powers the portable
system. Always charge all batteries before beginning a survey.
Portable system cable connections
Cable connections to the rear panels should be made before the
E6473B hub and the battery pack are loaded into the carry bag.
Cable connections to the front panels can be made after the
components are inserted into the carry bag. If the system is not
equipped with a receiver, no cable connections are made to the
rear panel of the E6473B hub.
Carry pack final assembly
1 Route the antenna, phone, and computer cables through the
openings provided.
2 Close all open panels.
3 Attach the clip-on receiver antenna to the pocket of pack. See
Figure 28 on page 60 for an example.
Using carry pack assembly with the shoulder strap
See Figure 26 on page 59 for an example.
1 Attach the shoulder strap to the D-rings.
2 Slip the shoulder strap around your neck.