Agilent Technologies Agilent E6474A - Manual (Page 64)

64 Agilent E6474A User’s Guide
3 Set Up Your System
Using the single-receiver backpack
1 Adjust the waist belt for a snug fit around your waist, then
remove it.
2 Feed the waist belt through the belt loops of the pack. The
black mesh should be on the outside.
3 Connect the two shoulder straps to the D-rings of the pack.
4 Mount the pack to your body, then connect the buckle of the
waist strap.
5 Adjust the shoulder straps.
6 Connect the chest strap to the D-rings of the shoulder straps.
7 Adjust all straps for a comfortable fit.
Portable dual E645xx receiver system
This section describes the cable connections for a system
equipped with two receivers. This configuration is housed in the
dual receiver back pack hub kit, E6473B option 024. The
backpack contains a removable mounting platform to which the
receivers and hub are attached.
Figure 31 Single receiver backpack (left side view)
Belt loop
D-ring for strap
Receiver Connector Panel
Battery Connector
D-ring for strap