Agilent Technologies Agilent E6474A - Manual (Page 56)

56 Agilent E6474A User’s Guide
3 Set Up Your System
1 Connect the battery charger cable to the battery.
2 Plug the battery charger’s AC power cord into a 100-240V AC
50-60 Hz power source.
3 Allow approximately three hours to fully charge the battery.
Safe handling and disposal
For the safe use of lithium-ion batteries, always follow the
instructions provided below. Improper handling of lithium-ion
batteries may result in injury or damage from electrolyte
leakage, heating, ignition, or explosion. Batteries must be
recycled or disposed of properly.
WARNING
Never charge the battery when the E6473B Hub is powered on. Use
only the approved charger, part no. E6473-60009.