Teledyne LeCroy WaveAce 1000_2000 Remote Control - Manual (Page 16)

WaveAce Remote Control
Status - Obtaining Status Information Using Status Registers
Short Form Long Form What the Command/Query Does
*CLS *CLS
Clears all status data registers.
*ESE *ESE Sets the standard Event Status Enable register (ESE).
*ESR? *ESR? Reads, clears the Event Status Register (ESR).
*OPC *OPC Sets the OPC bit in the Event Status Register (ESR).
ALST? ALL_STATUS?
Reads and clears the contents of all status registers.
CMR? CMR? Reads, clears the CoMmand error Register (CMR).
DDR? DDR? Reads, clears the Device Dependent Register (DDR).
EXR? EXR? Reads, clears the EXecution error Register (EXR).
INR? INR? Reads, clears INternal state change Register (INR).
Waveform Transfer – Creating and Preserving Waveforms
Short Form Long Form What the Command/Query Does
STO STORE
Stores a trace in internal memory or mass storage.
WF WAVEFORM Transfers a waveform from controller to scope.
WFSU WAVEFORM_SETUP Specifies amount of waveform data to go to controller.
14 920836 Rev B