Teledyne LeCroy WaveAce 1000_2000 Remote Control - Manual (Page 42)

WaveAce Remote Control
CURSOR - PARAMETER_VALUE?, PAVA?
The PArameter_VAlue query returns the current values of the pulse waveform parameters and mask
tests for the specified trace. Traces do not need to be displayed or selected to obtain the values
measured by the pulse parameters or mask tests.
Custom parameters can be read using the syntax CUST<n>, where <n> refers to lines 1 through 5 of the
parameter table to the right of the WaveAce display. The query returns values for all the parameters
assigned to that location using the PACU command.
Query Syntax
<trace>:PArameter_VAlue? [<parameter>,...,<parameter>]
OR
PArameter_VAlue? CUST<n>
Where:
<trace>:= {C1,C2,C3,C4,TA,TB,TC,TD}
<parameter>:=
Refer to parameter table.
<n>:= 1 to 5
Parameters
Parameter Definition
AMPL V Amplitude
BASE V Base
CRMS Root mean squared (current)
CMEAN V Average
DUTY + Duty cycle
FALL Fall time 90% to 10%
FFF Time between first falling edge of Source 1 and falling edge of Source 2
FFR Time between first falling edge of Source 1 and rising edge of Source 2
FPRE Falling edge preshoot
FREQ Frequency
FRF Time between first rising edge of Source 1 and falling edge of Source 2
FRR Time between first rising edge of Source 1 and rising edge of Source 2
LFF Time between last falling edge of Source 1 and falling edge of Source 2
LFR Time between last falling edge of Source 1 and rising edge of Source 2
LRF Time between last rising edge of Source 1 and falling edge of Source 2
LRR Time between last rising edge of Source 1 and rising edge of Source 2
40 920836 Rev B