Teledyne LeCroy WaveAce 1000_2000 Remote Control - Manual (Page 6)

WaveAce Remote Control
Remote Control Through USB
The USB interface is standard on every WaveAce oscilloscope. The rear panel USB port is the remote
control interface.
1. Attach a USB A/B cable from the USB-B port on the rear panel of the scope to a USB-A port on the
controller computer.
2. Install NI-VISA on the controller machine. NI-VISA contains the USB drivers needed to form the
interface between the oscilloscope and the controller. NI-VISA can be downloaded free from
www.ni.com/visa . You may use either the NI-VISA run-time or the full download. The run-time
download is significantly smaller.
You can send remote commands to the oscilloscope directly from the WaveStudio® terminal.
WaveStudio can be downloaded free at teledynelecroy.com/support/softwaredownload, under
Oscilloscope Downloads -> Oscilloscope Software Utilities.
4 920836 Rev B