Teledyne LeCroy WaveAce 1000_2000 Remote Control - Manual (Page 37)

Operator's Manual
CURSOR - CURSOR_MEASURE, CRMS
The CURSOR_MEASURE command specifies the type of cursor or parameter measurement to be
displayed, and is the main command for displaying parameters and Pass/Fail. Use it to turn on/off
cursors.
The CURSOR_MEASURE? query indicates which cursors or parameter measurements are currently
displayed.
Command Syntax
CuRsor_MeaSure <mode>
<mode>:= {HREL, VREL}
Where:
HREL
- Horizontal relative cursors.
VREL
- Vertical relative cursors.
Query Syntax
CuRsor_MeaSure?
Response Format
CuRsor_MeaSure <mode>
Example
The following instruction switches on the vertical relative cursors:
CRMS VREL
Related Commands
CURSOR_SET, PARAMETER_VALUE,
920836 Rev B 35