Teledyne LeCroy WaveAce 1000_2000 Remote Control - Manual (Page 20)

WaveAce Remote Control
ACQUISITION - *TRG
The *TRG command executes an ARM command. *TRG is the equivalent of the 488.1 GET (Group
Execute Trigger) message.
Command Syntax
*TRG
Related Commands
ARM_ACQUISITION, STOP, WAIT, FORCE_TRIGGER
ACQUISITION - ARM_ACQUISITION, ARM
The
ARM_ACQUISITION
command arms the scope or forces a single acquisition if it is already armed.
Command Syntax
ARM_acquisition
Related Commands
STOP, *TRG, TRIG_MODE, WAIT, FORCE_TRIGGER
ACQUISITION - AUTO_SETUP, ASET
The AUTO_SETUP command displays the input signal(s) by adjusting the vertical, timebase, and trigger
parameters. AUTO_SETUP operates on all channels.
If signals are detected on several channels, the lowest numbered channel with a signal determines the
selection of the timebase and trigger source.
If only one input channel is turned on, the timebase will be adjusted for that channel.
Command Syntax
Auto_SETup
18 920836 Rev B