Acquisition - trig_slope, trsl, Command syntax, Query syntax – Teledyne LeCroy WaveAce 1000_2000 Remote Control User Manual
Page 34: Response format, Example, Related commands
Advertising
WaveAce Remote Control
ACQUISITION - TRIG_SLOPE, TRSL
The TRIG_SLOPE command sets the trigger slope of the specified trigger source. The TRIG_SLOPE?
query returns the trigger slope of the selected source.
Command Syntax
<trig_source>:TRig_SLope <trig_slope>
<trig_source>:= {C1,C2,C3,C4,LINE,EX,EX5}
<trig_slope>:= {NEG, POS}
Query Syntax
<trig_source>:TRig_SLope?
Response Format
<trig_source>:TRig_SLope <trig_slope>
Example
The following instruction sets the trigger slope of Channel 2 to negative:
C2:TRSL NEG
Related Commands
TRIG_COUPLING, TRIG_DELAY, TRIG_LEVEL, TRIG_MODE, TRIG_SELECT, TRIG_SLOPE
32
920836 Rev B
Advertising