Teledyne LeCroy WaveAce 1000_2000 Remote Control - Manual (Page 36)

WaveAce Remote Control
ACQUISITION - WAIT
The WAIT command prevents your instrument from analyzing new commands until the current
acquisition has been completed. The optional argument specifies the timeout (in seconds) after which
the scope stops waiting for new acquisitions. If <t> is not given, or if <t> = 0.0, the scope waits
indefinitely.
Command Syntax
WAIT [<t>]
<t>:=
timeout in seconds (default is indefinite)
Example
ARM;WAIT;*OPC;C1:PAVA? MAX
This example finds the maximum amplitudes of several signals acquired one after another. ARM starts
a new data acquisition. The WAIT command ensures that the maximum is evaluated for the newly
acquired waveform.
C1:PAVA? MAX instructs the oscilloscope to evaluate the maximum data value in the Channel 1
waveform.
Related Commands
*TRG, TRIG_MODE, ARM
34 920836 Rev B