Teledyne LeCroy Conquest User Manual - Users Manual - Manual (Page 106)

Protocol Analysis
96
Data Report Settings
You have a number of choices to set up the way the data report is displayed.
To set up a data report view, right-click in the data report, then select
View Setting and Setting Dialog to open the Data Report Setting dialog.
Figure 73 Data Report Setting Dialog
Data Format
You can display the data in the report as Binary or ASCII, instead of the default
Hex, by checking the appropriate button.
View Format
You can display Transfers Only by checking the Transfers Only button and
set the Byte/Row to a value that matches the endpoint size of the device, to
allow a transaction to be on a single line without wrapping. Check the
Show ASCII Panel to display an ASCII interpretation of notes.
Data Offset
The default data address offset display is Hex. You can change it to decimal
by checking the Decimal button. You can also disable the data address offset
in the display by unchecking the Show Offset box.