Teledyne LeCroy Conquest User Manual - Users Manual User Manual
Page 85
Protocol Analysis
75
Specify data in Transaction layers
Transfers specified in Transaction layers are a flexible way to set up a
Transfer with different data patterns in each transaction for that transfer.
1. Insert a Transfer type, click Transactions No, and enter a number of
transactions. (The following example shows three entered).
2. Expand the transfer to display the created transactions.
3. Expand each transaction and enter data to transfer by that transaction.
Note: Data entered this way is limited to a maximum of 1024 bytes.
4. Specify the end point in the same way as described for byte transfers.
Figure 52 Transfer With 3 Transactions
Create a data block
For commands that involve data transfers, click the Data Block button and
define a data block. See page 86 for how to create data blocks.
Expand/Close
You can quickly expand/close Splits or Transfers by clicking the corresponding
button on the toolbar.
Choose # of transactions
Data to transfer
Expand/Close Splits
Expand/Close Transactions
Expand/Close Transfers