Teledyne LeCroy Conquest User Manual - Users Manual - Manual (Page 151)

Device Emulation (Optional)
141
1. Click the Supported Commands tab to open the
Supported Commands Entry dialog, as shown in Figure 105.
Figure 105 Supported Commands Entry Dialog
2. Click the Add button to open the command name dialog.
Figure 106 Adding a New Command
3. Enter the command name and click OK.
4. You can also select the default New Command and rename it.
5. Click the transaction button on the dialog toolbar to display the
transaction drop-down list.
6. Choose a Setup or Out transaction as the command stage and make
sure to change the endpoint number to a non-zero one.
7. Edit the data payload of the data packet to a value.
8. Complete the data and status stage of the command set by adding
addition in or out transaction to any endpoint.