Teledyne LeCroy Conquest User Manual - Users Manual User Manual
Page 59
Advertising
Protocol Analysis
49
Define Loops
To define program loops, click under Loops in the program line in which to
start the loop and click Start. Similarly click under Loops in the program line in
which to end the loop and click End. See page 50 for setting the number of
times to run the loop.
Enable Exerciser
Make sure that the Run Exerciser check box is checked.
Choose Trigger and Capture Options
Click the Data Capture and Trigger tab, then choose a Trigger and Data
Capture option or options to analyze the traffic generated by the exerciser.
Figure 28 Sample Trigger and Data Capture Selection
Click Run to exercise the Device and wait for the captured results to display,
as shown in Figure 29.
Figure 29 Captured Data Display
Advertising