Teledyne LeCroy Conquest User Manual - Users Manual User Manual
Page 146
Device Emulation (Optional)
136
Activate Device
Click the Deactivate Device button to activate the Device. Note the
“Device: Active” indication on the taskbar displays green.
Note 1 After setup is complete, you do not have to activate the device immediately.
You can close the dialog, perform other tasks, and then activate the device.
Note 2 To make the just-defined Project the Default Project, click the Save button on
the main toolbar. However, to leave a previously defined Default Project intact,
select File on the main toolbar and choose Save As to save the project with a
new name.
Delayed Device Activation
Click the down arrow next to the Device button on the Task Bar
to open the Device dialog and then check the Activate Device Emulation
check box.
Note that this menu also applies to OTG Exerciser activation.
Set Up Analysis
Set up an analysis in either Easy mode (see page 33) or Advanced mode (see
page 55) and click Run.
Connect to Device Port
Connect the cable to the Device port or click the Attach Device button on the
main toolbar.