Teledyne LeCroy Conquest User Manual - Users Manual - Manual (Page 141)

Device Emulation (Optional)
131
The Device Emulation dialog opens with a default hierarchy as shown in
Figure 99.
Figure 99 Device Mode Setup Dialog
You can add configurations to a total of three. Each configuration by default
opens with one interface. You can add interfaces to total two per configuration.
Each interface by default opens with one Alternative Setting with one
endpoint. You can add Alternative Settings to total four for each interface, but
no more than seven total for the Device. A Device can have a total of seven
endpoints. You can enter descriptor values at each level of the hierarchy.
In addition to support for most standard requests defined for USB, you can
configure the Device to respond with up to four arbitrary standard request data
descriptors and up to seven String Descriptor strings and to acknowledge up
to eight class requests.
Define the Device
1. Assign the Device speed from the Device Speed drop down list as Low,
Full, or High/Full. Note that in High/Full speed, you must set up two
independent Devices.
2. Enter Vendor and Product ID in the appropriate text box.