Teledyne LeCroy Conquest User Manual - Users Manual - Manual (Page 113)

Protocol Analysis
103
Click Add to access previously created protocol script files.
Figure 81 Choosing a Custom Script File
Choose a script file from the Select Script File dialog, then click Open to add
this file to the Defined Protocols list. Repeat for additional protocols.
You can now assign this protocol as described on page 101.
Note: Two types of High Level decodes are in the Assigned Protocols window:
• Pre-defined protocols included with the system
• Custom protocols that you create using the ASL script
Errors in User-Defined Scripts
Errors in user-defined scripts are logged as a result of script file parsing the
first time that the script is run on the system. An appropriate error message is
displayed and a text file of errors is generated and saved in the same folder as
the source script file.
Note: The first time you open the software after installation, the software compiles the
decoding files in the SystemData\UDDcfg and SystemData\Cfg folders. If
you remove decoding files from these directories, by deleting or by moving
files to another folder, the software recompiles the decoding files the next time
you open the software. If you do not remove decoding files from the
SystemData\UDDcfg and SystemData\Cfg directories, the software does not
compile the decoding files again.
You can modify decoding files directly by using any text editor or the
application tool. Example source decoding files are in the
Examples\UDDScripts folder. For examples of script modification using the
software tool, you can open and modify the .asl files in the
Examples\UDDScripts using the application. If you modify decoding files in
the application, you must verify them. It is recommended that you save the
example file before using the UDD script. For information on how to modify or
create new scripts, see “Appendix A” on page 203.