Teledyne LeCroy Conquest User Manual - Users Manual User Manual
Page 176
Advertising
Current Measurement (Optional)
166
Click the Run button and follow the on-screen prompts.
Plug the Device into the Inrush port, click OK, and wait for the next prompt.
Unplug the Device from the inrush port, click OK, and wait for the next prompt.
Plug the Device back into the Inrush port. If this action does not open the
result display, the inrush current is below the minimum threshold detected by
Conquest M2. In this case, you can perform the measurement again by
clicking Run.
You may receive the following message:
Advertising