Avaya Sun Fire V880 - Manual (Page 152)

Troubleshooting
152 Avaya CMS Sun Fire V880 Computer Hardware Installation, Maintenance, and Troubleshooting
Using the remote console
If your system does not boot, or if the system cannot be diagnosed locally, remote support
personnel might want to redirect control of the console port from the local console to a
dialed-in remote console. Redirecting the console allows support personnel to do
maintenance remotely as if they were at the local console. You can redirect the console
using either:
●
The Solaris operating system
●
OpenBoot diagnostics
This section consists of the following procedures:
●
Redirecting the console using Solaris on page 152. Use this procedure when the
system will boot up to the Solaris operating system.
●
Redirecting the console using OpenBoot mode on page 155. Use this procedure when
the system will not boot up to the Solaris operating system.
Redirecting the console using Solaris
The following procedure describes how to use the Solaris operating system to redirect the
local console to the serial port and is usually done from the remote console that has dialed
in to the system. Should you encounter any problems setting up the remote console, see
Remote console port problems on page 200 for troubleshooting procedures.
!
CAUTION:
CAUTION:
Use the following procedure only when absolutely necessary. If the console
redirects and the modem line drops, you may not be able to get back into the
system.
Redirecting the local console to the remote console
To redirect control of the console port from the local console to a dialed-in remote console:
1. Dial in from the remote console to the remote console modem, and log in as root.
2. At the remote console, enter:
/cms/install/bin/abcadm -r ttya
The following message is displayed at the remote console:
ttya is currently set to be incoming
Are you sure you want to change it? [y,n,?]