Installing a hot-plug pci card, With – Avaya Sun Fire V880 User Manual
Page 68
Maintenance
68 Avaya CMS Sun Fire V880 Computer Hardware Installation, Maintenance, and Troubleshooting
Installing a hot-plug PCI card
To install a card:
1. Enter:
cfgadm
This displays the PCI card configuration before you add a card. Make sure the slot is
available for a new card. Recheck the configuration after you have added the card.
2. Make sure that the front panel key switch is not in the locked position. If it is, move the
key switch to the diagnostic or normal position.
3. Open the left door.
4. Attach one end of an ESD antistatic wrist strap to the system chassis sheet metal and
attach the other end to your wrist. See
information.
5. Identify the slot in which you want to install a card.
6. If not already done, pinch the purple PCI card retaining clip until it releases from the
back of the card and rotate the clip outward. See the following figure.
7. If not already done, remove the filler panel from the slot.
8. Confirm that all three LEDs for the slot are off.