Avaya Sun Fire V880 - Manual (Page 197)

Recovery procedures
Issue 2.0 June 2004 197
9. Reinsert the HSI/P card into the slot on the I/O board. Make sure that the card is fully
seated.
10. Rotate the purple PCI retaining clip over the back of the card faceplate until it snaps
into place.
11. Remove the ESD wrist strap.
12. Close the left door.
13. Reattach the HSI/P quad cable.
14. Turn on any external SCSI devices, starting with the device that is farthest from the
system and working toward the system.
15. Turn on the system monitor.
16. Turn on the system. Do not put the keyswitch in the locked position.
17. When the system comes back up, log in as root.
18. Test the card to see if it is now working. If the card is still not working, see Replacing an
HSI/P card on page 73.