Avaya Sun Fire V880 - Manual (Page 42)

Installation
42 Avaya CMS Sun Fire V880 Computer Hardware Installation, Maintenance, and Troubleshooting
6. Enter:
cu -s 9600 -b 8 -l cua/a
The following message is displayed:
7. Enter the following commands:
at&f1
(loads the factory default configuration into active memory)
at&w0
(writes the current configuration to NVRAM template Y0)
Note:
Note:
Use numerical ones and zeros when entering the options.
8. After you enter the options, disconnect from the modem by entering a tilde and a
period (~.).
9. Set DIP switches 4 and 8 on the back panel of the Sportster modem to the down (ON)
position. Set all other DIP switches to the up (OFF) position.
10. Reset the modem by turning the power off and back on.
11. Enter:
/cms/install/bin/abcadm -i -b 9600 ttya
The Terminal Ready (TR) LED lights on the modem and the following message is
displayed:
12. If the TR LED is not lit, enter:
ps -ef | grep sac
A message similar to the following should be displayed:
Additional references - For additional information, see the U.S. Robotics Sportster
Modems Users Guide.
Connected
ttya set to incoming port 9600 baud
root 377 1 0 14:39:30 ? 0:00 /usr/lib/saf/sac -t 300
root 9723 9666 0 09:16:26 pts/9 0:00 grep sac