Avaya Sun Fire V880 User Manual
Page 92
Maintenance
92 Avaya CMS Sun Fire V880 Computer Hardware Installation, Maintenance, and Troubleshooting
14. Insert the HSI/P card into slot 4 on the I/O board. Make sure that the card is fully
seated. See the following figure.
15. Rotate the purple PCI retaining clip over the back of the card faceplate until it snaps
into place.
16. Remove the ESD wrist strap.
17. Close the left door.
18. Attach the HSI/P quad cable, and connect the switch links to the quad cable by
following the instructions described in Avaya Call Management System Switch
Connections, Administration, and Troubleshooting.
19. Turn on any external SCSI devices, starting with the device that is farthest from the
system and working toward the system.
20. Turn on the system monitor.
21. Turn on the system. Do not put the keyswitch in the locked position.
As the system powers up, the power LED on the monitor flashes.
22. Press Stop+A simultaneously as soon as the monitor power LED lights steadily and
the Sun logo is displayed on the monitor.
The ok prompt is displayed.