Avaya Sun Fire V880 - Manual (Page 201)

Recovery procedures
Issue 2.0 June 2004 201
6. Enter:
kill -9 <pid>
Use this command to kill any SAC processes still running. Process numbers are
represented by <pid>.
7. Enter:
/usr/lib/saf/sac -t 300
This restarts SAC.
8. Enter:
sacadm -l
Confirm that SAC is running. The system should report the port status as ENABLED.
9. Enter:
/cms/install/bin/abcadm -i -b 9600 ttya
The following message should be displayed:
If this message is not displayed, escalate the problem using the normal channels.
Symptom - The system cannot dial out to report alarms using the Alarm Origination
Manager (AOM).
Solution - To correct this problem:
1. Enter:
tail /etc/uucp/Devices
The system should display the following:
2. Check the settings on the remote console modem. For the U.S. Robotics modem,
make sure that DIP switches 1 and 8 are down (ON). If these switches are not set
correctly, you may still be able to dial in, but it may not dial out.
3. Enter:
/opt/cc/install/aot/r1vXxx.x/bin/setup
This restarts AOM. The release number Xxx.x depends on your installation.
ttya set to incoming port 9600 baud
ACU cua/b - Any Hayes
Direct cua/a - Any Direct
Direct cua/b - Any Direct