Avaya Sun Fire V880 - Manual (Page 39)

Identifying installed PCI cards
Issue 2.0 June 2004 39
Identifying installed PCI cards
If there are problems with the PCI cards, do the following to troubleshoot the problem. If all
PCI cards are operational, you can skip this procedure.
At the command prompt, enter:
/usr/platform/‘uname -m‘/sbin/prtdiag -v | pg
In the section IO Cards, there is a listing of the PCI cards. The following are examples of
some of the entries you may see. The display you see depends on your specific
configuration.
In this example:
●
Slot 0 has a Dual FastEthernet and Dual SCSI card. There is more than one entry for a
this card because the card has two SCSI ports and two Ethernet ports.
●
Slot 1 has a FastEthernet card. There is more than one entry for the FastEthernet card
because the card has the ethernet port and a Media Independent Interface (MII) port
(not used with CMS).
●
Slot 3 has an HSI/P card.
●
Slot 7 has a graphics card.
.
.
========================= IO Cards =========================
Bus Max
IO Port Bus Freq Bus Dev,
Brd Type ID Side Slot MHz Freq Func State Name
Model
---- ---- ---- ---- ---- ---- ---- ---- ----- ------------------------------------------------------
I/O PCI 8 B 3 33 33 2,0 ok pci1214,334-pci1214,334.10
I/O PCI 8 B 1 33 33 4,0 ok pci108e,1000-pci108e,1000.1
I/O PCI 8 B 1 33 33 4,1 ok SUNW,hme-pci108e,1001 SUNW,qsi-cheerio
I/O PCI 9 B 0 33 33 3,0 ok pci-pci8086,b154.0/network (netw+PCI-BRIDGE
I/O PCI 9 B 0 33 33 0,0 ok network-pci100b,35.30 SUNW,pci-ce/pci-bridge
I/O PCI 9 B 0 33 33 1,0 ok network-pci100b,35.30 SUNW,pci-ce/pci-bridge
I/O PCI 9 B 0 33 33 2,0 ok scsi-pci1000,b.7/disk (block) device on pci-bridge
I/O PCI 9 B 0 33 33 2,1 ok scsi-pci1000,b.7/disk (block) device on pci-bridge
I/O PCI 9 A 7 66 66 2,0 ok SUNW,XVR-100 SUNW,375-3181
.
.