Avaya Sun Fire V880 User Manual
Page 173
Tools
Issue 2.0 June 2004
173
7
controller@0,16
Tests the base backplane firmware and SSC-100 SES
controllers.
8
controller@0,1a
9
controller@0,1c
Tests the expansion backplane firmware and SSC-100
SES controllers. Use only on 12-disk systems.
10
controller@0,1e
11
ebus@1
Tests the PCI configuration registers, DMA control
registers, ebus mode registers, and DMA controller
functions.
12
flashprom@0,0
Performs a checksum of the flash PROM containing the
OpenBoot firmware.
13
gpio@1,300600
Tests the registers of the super I/O subsystem.
14
hot plug-controller@0,
Performs a hot-plug test of the PCI slots.
!
CAUTION:
CAUTION:
After the hot-plug test, the PCI cards in the
slots are not usable until you reset the
system.
15
hot plug-controller@0,
16
hot plug-controller@0,
17
hot plug-controller@0,
18
i2c@1,2e
Tests the devices monitored by the I
2
C environmental
monitoring bus (temperature sensors, fans, power
supplies, system fault LEDs, thermal fault LEDs, and front
panel key switch).
19
i2c@1,30
20
i2c@1,50002e
21
i2c@1,500030
22
keyboard@1
Tests the USB keyboard.
23
network@1
Tests the on-board Gigabit Ethernet (GBE) logic, including
internal and external loopback tests.
24
network@1,1
Tests the on-board Fast Ethernet logic, including internal
and external loopback tests.
25
pmc@1,300700
Tests the registers of the power management controller.
26
rsc-control@1,3062f8
Tests RSC hardware, including RSC serial and Ethernet
ports.
27
rtc@1,300700
Tests the registers of the real-time clock and then tests the
interrupt rates.
28
scsi@1
Tests the on-board SCSI controller and SCSI bus
subsystem for internal removable media devices. Checks
associated registers and performs a DMA transfer.
Command
number
Command name
Description