ADTRAN 600R - Manual (Page 122)

Section 4 User Interface Guide Total Access 600 Series System Manual
120 © 2004 ADTRAN, Inc. 61200624L1-1B
R OUTER > C ONFIG > I NTERFACES (ETH) > S UB -I NTERFACE
This is a read-only field which displays the physical and logical port of the interface using the following
nomenclature: [A.B], where A represents the physical port (network interface is 0, Ethernet is 1) and B
represents the logical port for the Layer 2 protocol (i.e. PVC for Frame Relay, PPP link, etc.) Each
configured logical port is assigned a number corresponding to the order in which they are listed in the L2
Protocol configuration fields.
R OUTER > C ONFIG > I NTERFACES (ETH)> S ETUP
Configure the Ethernet addressing, RIP, and Proxy ARP from this menu.
P RIMARY IP
This is used to setup the IP addresses for the LAN on the unit.
IP A DDRESS
The IP address assigned to the unit's Ethernet port is set here. This address must be unique within
the network. Default is
10.0.0.1 .
S UBNET M ASK
This is the IP network mask that is to be applied to the unit's Ethernet port. Default is
255.255.255.0.
RIP
Use this menu to enable RIP on the LAN interface.
V ERSION
Enables or disables RIP and specifies the RIP protocol. Choices are; O FF
(which disables
RIP), V1 (RIP Version 1) or V2 (RIP Version 2). The default is O FF
.
M ETHOD
Specifies the way the RIP protocol sends out its advertisements. The following options are
available:
S PLIT H ORIZON (DEF)
Only routes not learned from this circuit are advertised.
P OISON R EVERSE
All routes are advertised, but the routes learned from this port are “poisoned” with an
infinite metric. The default is Split Horizon.
D IRECTION
Allows the direction at which RIP advertisements are sent and received to be specified.