ADTRAN 600R - Manual (Page 207)

Total Access 600 Series System Manual Section 5 DLP-7
61200624L1-1B © 2004 ADTRAN, Inc. 205
9. Select S TART T RANSFER to start the update. Enter Y to confirm the upgrade.
Prior to the start of the upgrade, the transfer status will display I DLE
. During the TFTP upload process,
various status messages display in C URRENT U PDATE S TATUS
to indicate progress. The following table
describes these messages.
10. When the update has successfully completed, F LASH P ROGRAMMED S UCCESSFULLY displays briefly in
the T RANSFER S TATUS field. This will be followed by a L OADED C ODE VER X . X . X C HKSUM = XXXX
message. Finally the T RANSFER S TATUS field displays R ESETTING ...
The Total Access 6XX will restart immediately and resume operation. After giving the unit sufficient
time to reboot, the user may Telnet back into the unit and log in.
Message Meaning
Transferring... [X KB]
Indicates communication with the TFTP network server has been
established and the update file is being transferred between the
Total Access 6XX and the TFTP network server.
Flash Programmed
Successfully
The unit has been upgraded successfully.
Loaded code
ver x.x.x
chksum = xxxx
Unit displays the version and checksum of the upgraded code.
Resetting .... Unit is power cycling.
RECV Error Unit will display this message if server filename is incorrect.
Can not start tftp
client
**Reload
Unit will display this message if TFTP server address is incorrect.
Transfer aborted User has selected A BORT T RANSFER .